IBM X3400 M4 RAID DRIVER

If you can help here that would be appreciated. Unable to attach storage volume, error device number out of range” The error-messages indicates there was a problem when initializing the raid array. All help and support will be much appreciated. Message 3 of 6. This website uses cookies. From the CLI enter:

Uploader: Daigrel
Date Added: 20 October 2005
File Size: 54.13 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 61468
Price: Free* [*Free Regsitration Required]

Best wishes and thanks again Budgie1. See this link for information to Contact DataPower Support.

Rebuilding a RAID 1 array

When initialized the raid directory will be accessible from the “local” and “logstore” directories. Hi Boogie, have exactly the same problem you have.

Hi and thanks for the reply. This helped me too. Where in the boot process can I set up the drives? By browsing this website, you consent to the use of cookies.

Rebuilding a RAID 1 array

This will present a list of the storage devices on your system, select the M and the configuration options will become available. Feed for this topic. Grateful for any further thoughts and thanks again for the reply.

Follow these steps if using the CLI and logged in as admin: If one is “offline”, Contact DataPower Support. You can use the “raid volumes” status provider to monitor the “Resync Ibbm If “Enabled” is false or there is no resync in progress and the LED’s are on check the “Physical disk” status. I am attaching the results of the DSA. Sorry for the delayed reply.

See Also  TELEGESIS USB TREIBER WINDOWS XP

It may be easy to use for you. This technote lists the recommended steps for setting up the RAID disk array to avoid unpredictable results that may include the device becoming unresponsive as well as troubleshooting steps if there are problems with the raid array.

I found that I could rebuild the array by forcing back on line. I also read somewhere that I should upgrade the back plane firmware after upgrading the serveraid firmware but cannot find how to do this or the relevant download.

There are indications that I should also update the backplane firmware but I cannot find the right file. Try unplug power cables and replug them after minute, update controller firmware upto fresh version.

From the WebGUI select: News Abstract This technote lists the recommended steps for setting up the RAID disk array to avoid unpredictable results that may include the device becoming unresponsive ibk well as troubleshooting steps if there are problems with the raid array. To activate the array you may use either of the following procedures: How can we do it?

See Also  SPREADTRUM SMARTPHONE DRIVERS DOWNLOAD

To remove the raid array from the configuration: If you can help here that would be appreciated. JBOD storage in an x M5 Lenovo is committed to environmental leadership from operations to product design and recycling solutions.

Solved: X M3 RAID Configuration Problem – Lenovo Community

Forums Knowledge Base Blogs. I did not chose quick start for building the array and it has been building for more than 36 hours so I am wondering if there is another problem with the serveraid.

To identify the location for a file type logging target to use the raid directory use the format: Log in to reply. Follow the steps and notes above. I have just had an x fail to boot and find that the raid array has been “lost.